MicroMegaWattBSP¶
Driver module for the Micro Mega Watt DC Charging Tester v1.0
Auto-Generated Reference¶
Module Configuration¶
serial_port: string <optional>
default: “/dev/ttyUSB0”
Serial port the uMWC hardware is connected to
baud_rate: integer <optional>
default: 115200
Serial baud rate to use when communicating with uMWC hardware
reset_gpio_chip: string <optional>
default: “gpiochip0”
Reset GPIO chip to use to HW reset uMWC. If set to empty string, it is disabled.
reset_gpio: integer <optional>
default: 27
GPIO line to use to reset uMWC
dc_max_voltage: integer <optional>
default: 1000
Maximum voltage to support
connector_id: integer <optional>
default: 1
Connector id
Provides¶
dc_supply: power_supply_DC
Interface for the DC/DC output supply
powermeter: powermeter
Interface for the powermeter
board_support: evse_board_support
provides the board support Interface to low level control control pilot, relais, rcd, motor lock