.. _everest_modules_MicroMegaWattBSP:

################
MicroMegaWattBSP
################
| Driver module for the Micro Mega Watt DC Charging Tester v1.0



************************
Auto-Generated Reference
************************


Module Configuration
====================
| **serial_port**: *string* <optional>
| *default: "/dev/ttyUSB0"*
|  Serial port the uMWC hardware is connected to
| **baud_rate**: *integer* <optional>
| *default: 115200*
|  Serial baud rate to use when communicating with uMWC hardware
| **reset_gpio_chip**: *string* <optional>
| *default: "gpiochip0"*
|  Reset GPIO chip to use to HW reset uMWC. If set to empty string, it is disabled.
| **reset_gpio**: *integer* <optional>
| *default: 27*
|  GPIO line to use to reset uMWC
| **dc_max_voltage**: *integer* <optional>
| *default: 1000*
|  Maximum voltage to support
| **connector_id**: *integer* <optional>
| *default: 1*
|  Connector id

Provides
========
| **dc_supply**: :ref:`power_supply_DC <everest_interfaces_power_supply_DC>`
|  Interface for the DC/DC output supply
| **powermeter**: :ref:`powermeter <everest_interfaces_powermeter>`
|  Interface for the powermeter
| **board_support**: :ref:`evse_board_support <everest_interfaces_evse_board_support>`
|  provides the board support Interface to low level control control pilot, relais, rcd, motor lock


********
Metadata
********
Authors
=======
| Cornelius Claussen

License
=======
| https://opensource.org/licenses/Apache-2.0