11.1.31. YetiDriver¶

Driver module for the YETI hardware v1.0

For a detailed handwritten documentation see here

11.1.31.1. Module Configuration¶

serial_port:string

default: /dev/ttyUSB0

Serial port the Yeti hardware is connected to

baud_rate:integer

default: 115200

Serial baud rate to use when communicating with Yeti hardware

control_mode:string

default: low

none, high or low

enum: none, high, low

reset_gpio:integer

default: -1

Reset GPIO number to use to HW reset Yeti. If set <0 it is disabled.

caps_min_current_A:integer

default: -1

Minimal current on AC side. For AC this is typically 6, but for HLC this can be less. -1 means use limit reported by HW.

powermeter:powermeter

provides the Yeti Internal Power Meter

provides the board support Interface to low level control control pilot, relais, motor lock

rcd:ac_rcd

RCD interface of the onboard RCD

connector_lock:connector_lock

Interface for the motor lock

Cornelius Claussen
Kai-Uwe Hermann
Thilo Molitor
Anton Wöllert