11.1.31. YetiDriver¶
Driver module for the YETI hardware v1.0
For a detailed handwritten documentation see here
11.1.31.1. Module Configuration¶
serial_port:string <optional>
default: “/dev/ttyUSB0”
Serial port the Yeti hardware is connected to
baud_rate:integer <optional>
default: 115200
Serial baud rate to use when communicating with Yeti hardware
control_mode:string <optional>
default: “low”
none, high or low
enum:
- none
- high
- low
reset_gpio:integer <optional>
default: -1
Reset GPIO number to use to HW reset Yeti. If set <0 it is disabled.
caps_min_current_A:integer <optional>
default: -1
Minimal current on AC side. For AC this is typically 6, but for HLC this can be less. -1 means use limit reported by HW.
11.1.31.2. Provides¶
powermeter:powermeter
provides the Yeti Internal Power Meter
board_support:evse_board_support
provides the board support Interface to low level control control pilot, relais, motor lock
rcd:ac_rcd
RCD interface of the onboard RCD
connector_lock:connector_lock
Interface for the motor lock
Get Support
YouTube Channel
Twitter