.. _everest_interfaces_ev_board_support:


################
ev_board_support
################

| This defines the board support package for the EV side


*********
Variables
*********
| **bsp_event**:*object*  (:ref:`board_support_common-BspEvent <board_support_common-BspEvent>`)
|  Events from CP/Relais
|  **There is an extended definition for this object** :ref:`here <board_support_common-BspEvent>`.
| **bsp_measurement**:*object*  (:ref:`board_support_common-BspMeasurement <board_support_common-BspMeasurement>`)
|  BSP Measurements
|  **There is an extended definition for this object** :ref:`here <board_support_common-BspMeasurement>`.

********
Commands
********
| **enable**:*void*
|  Enable/disable the simulation
|  **value**:*boolean* <required>
|   true to enable, false to disable
| **set_cp_state**:*void*
|  Sets the CP State that should be set by the EV board support driver (controlled by S2)
|  **cp_state**:*string* <required> (:ref:`ev_board_support-EvCpState <ev_board_support-EvCpState>`)
|   The CP State
|   **There is an extended definition for this object** :ref:`here <ev_board_support-EvCpState>`.
| **allow_power_on**:*void*
|  Sets allow_power_on flag. If false, contactor must never be switched on.
|  **value**:*boolean* <required>
|   True: allow power on, false: do not allow power on.
| **diode_fail**:*void*
|  Setting a diode failure
|  **value**:*boolean* <required>
|   True: diode failure
| **set_ac_max_current**:*void*
|  Setting the max current requested from the ev
|  **current**:*number* <required>
|   Max current requested from the ev
| **set_three_phases**:*void*
|  Setting three or one phase support
|  **three_phases**:*boolean* <required>
|   True: Three phase support, False: One phase support
| **set_rcd_error**:*void*
|  Setting a rcd error. Only for simulation purpose.
|  **rcd_current_mA**:*number* <required>
|   RCD current in mA