13.1.36. YetiDriver¶

Driver module for the YETI hardware v1.0

For a detailed handwritten documentation see here

13.1.36.1. Module Configuration¶

serial_port:string <optional>

default: “/dev/ttyUSB0”

Serial port the Yeti hardware is connected to

baud_rate:integer <optional>

default: 115200

Serial baud rate to use when communicating with Yeti hardware

reset_gpio_chip:string <optional>

default: “gpiochip0”

Reset GPIO chip to use to HW reset Yeti. If set to empty string, it is disabled.

reset_gpio:integer <optional>

default: 27

GPIO line to use to reset Yeti

caps_min_current_A:integer <optional>

default: -1

Minimal current on AC side. For AC this is typically 6, but for HLC this can be less. -1 means use limit reported by HW.

caps_max_current_A:integer <optional>

default: -1

Maximum current on AC side. For AC this is typically 16 or 32, but for HLC this can be less. -1 means use limit reported by HW.

powermeter:powermeter

provides the Yeti Internal Power Meter

provides the board support Interface to low level control control pilot, relais, motor lock

rcd:ac_rcd

RCD interface of the onboard RCD

connector_lock:connector_lock

Interface for the motor lock

Cornelius Claussen
Kai-Uwe Hermann
Thilo Molitor
Anton Wöllert